DIY     OBD-II Codes     Fix your Car     Repair Manuals     -Forum-

Advertisement  [ ? ]

Site Links

Honda Fit/Jazz - DTC Troubleshooting: P0137 (63-1) (5MT)

Online Honda Fit/Jazz 2002-2005 Workshop repair manual used by professionals.

Full Membership required

We can not locate your Full (Preferred) membership details. Please login to your account first and if necessary upgrade your membership.
24 Hr or Annual Membership required.

Thank you!

Snip from the Manual


DTC Troubleshooting: P0137 (63-1)

DTC P0137 (63-1): Secondary HO2S (Sensor 2) Circuit Low Voltage


1.Reset the ECM/PCM.

2.Start the engine. Hold the engine at 3,000 rpm (min-1) with no load (in Park or neutral) until the radiator fan comes on.

3.Check the secondary HO2S (Sensor 2) output voltage at 3,000 rpm (min-1) with the scan tool.

Does the voltage stay at 0.3 V or less?


YES - Go to 4.


NO - Intermittent failure, system is OK at this time. Check for poor connections or loose wires at the secondary HO2S (Sensor 2) and at the ECM/PCM.n


4.Turn the ignition switch OFF.

5.Disconnect the secondary HO2S (Sensor 2) 4P connector.

6.Turn the ignition switch ON (II).

7.Check the secondary HO2S (Sensor 2) output voltage with the scan tool.

Does the voltage stay at 0.3 V or less?


YES - Go to 8.


NO - Replace the secondary HO2S (Sensor 2).n


8.Turn the ignition switch OFF.

9.Disconnect the negative cable from the battery.

10.Disconnect ECM/PCM connector E (31P).

11.Check for continuity between the secondary HO2S (Sensor 2) 4P connector terminal No. 2 and body ground.

IMAGE REPLACED HERE

Is there continuity?


YES - Repair short in the wire between the ECM/PCM (E2) and the secondary HO2S (Sensor 2).n


NO - Substitute a known-good ECM/PCM and recheck. If symptom/indication goes away, replace the original ECM/PCM.n

5. Disconnect


Honda Fit/Jazz 02-05 Workshop Manual    Back to all Manuals