DIY     OBD-II Codes     Fix your Car     Repair Manuals     -Forum-

Advertisement  [ ? ]

Site Links

Honda Fit/Jazz - DTC Troubleshooting: P0443 (92-4) (5MT without ETCS)

Online Honda Fit/Jazz 2002-2005 Workshop repair manual used by professionals.

Full Membership required

We can not locate your Full (Preferred) membership details. Please login to your account first and if necessary upgrade your membership.
24 Hr or Annual Membership required.

Thank you!

Snip from the Manual


DTC Troubleshooting: P0443 (92-4)

DTC P0443 (92-4): EVAP Canister Purge Valve Malfunction


1.Reset the ECM/PCM.

2.Start the engine. Hold the engine at 3,000 rpm (min-1) without load (in Park or neutral) until the radiator fan comes on.

Is the DTC P0443 indicated?


YES - Go to 3.


NO - Intermittent failure, system is OK at this time. Check for poor connections or loose terminals between the EVAP canister purge valve and at the ECM.n


3.Turn the ignition switch OFF.

4.Disconnect the vacuum hose (A) from the EVAP canister purge valve (B) and connect a vacuum gauge (C) to the hose.

IMAGE REPLACED HERE

5.Start the engine end let it idle.

Is there vacuum?


YES - Go to 6.


NO - Go to 11.


6.Turn the ignition switch OFF.

7.Disconnect the EVAP canister purge valve 2P connector.

8.Check for continuity between the EVAP canister purge valve 2P connector terminal No. 2 and body ground.

IMAGE REPLACED HERE

Is there continuity?


YES - Go to 9.


NO - Replace the EVAP canister purge valve.n


9.Disconnect ECM/PCM connector B (24P).

10.Check for continuity between the EVAP canister purge valve 2P connector terminal No. 2 and body ground.

IMAGE REPLACED HERE

Is there continuity?


YES - Repair short in the wire between the EVAP canister purge valve and the ECM/PCM (B21).n


NO - Update the ECM/PCM if it does not have the latest software, or substitute a known-good ECM/PCM, then recheck. If the symptom/indication goes away with a known-good ECM/PCM, replace the original ECM/PCM.n

11.Turn the ignition switch OFF.

12.Disconnect the EVAP canister purge valve 2P connector.

13.Turn the ignition switch ON (II).

14.At the harness side, measure voltage between the EVAP canister purge valve 2P connector terminal No. 1 and body ground.

IMAGE REPLACED HERE

Is there battery voltage?


YES - Go to 15.


NO - Repair open in the wire between No. 3 (7.5A) fuse in the under-dash fuse/relay box and the EVAP canister purge valve.n


15.Turn the ignition switch OFF.

16.Reconnect the EVAP canister purge valve 2P connector.

17.Turn the ignition switch ON (II).

18.Measure voltage between ECM/PCM connector terminals A5 and B21.

IMAGE REPLACED HERE

Is there battery voltage?


YES - Update the ECM/PCM if it does not have the latest software, or substitute a known-good ECM/PCM, then recheck. If the symptom/indication goes away with a known-good ECM/PCM, replace the original ECM/PCM.n


NO - Repair open in the wire between the EVAP canister purge valve and the ECM/PCM (B21). If wire is OK, replace the EVAP canister purge valve.n

5. Start


Honda Fit/Jazz 02-05 Workshop Manual    Back to all Manuals