Advertisement [ ? ]
Site Links
- Lease Calculator
- Advertise
- My Car ongoing Review
- Members' Chat
- Cars For Sale
- Car Dealers
- Honda "Fit" Manual
- Hyperflex Bushings
- For Sale
- Fix your Car
- Car Manuals
- other manuals - Reference Materials
- DIY Repairs
- Articles
- Video
- Link with Us
- Search Help
- Code your Mac!
- Fly, race, anything R/C
Honda Fit/Jazz - DTC Troubleshooting: P0108 (3-2) (L12A/L13A 5MT without ETCS)
Online Honda Fit/Jazz 2002-2005 Workshop repair manual used by professionals.
Full Membership required
We can not locate your Full (Preferred) membership details. Please login to your account first and if necessary upgrade your membership.
24 Hr or Annual Membership required.
Thank you!
Snip from the Manual
DTC Troubleshooting: P0108 (3-2)
DTC P0108 (3-2): MAP Sensor Circuit High Voltage
1.Start the engine. Hold the engine at 3,000 rpm (min-1) with no load (in Park or neutral) until the radiator fan comes on, then let it idle.
2.Check the MAP with the HDS or the scan tool.
Is about 101 kPa (760 mmHg, 30 in.Hg) or higher, or about 2.9 V or higher indicated?
YES - Go to 3.
NO - Intermittent failure, system is OK at this time. Check for poor connections or loose terminals at the MAP sensor and at the ECM/PCM.n
3.Turn the ignition switch OFF.
4.Disconnect the MAP sensor 3P connector.
5.Connect the MAP sensor 3P connector terminals No. 2 and No. 3 with a jumper wire.
IMAGE REPLACED HERE
6.Turn the ignition switch ON (II).
7.Check the MAP with the HDS or the scan tool.
Is about 101 kPa (760 mmHg, 30 in.Hg) or higher, or about 2.9 V or higher indicated?
YES - Go to 8.
NO - Replace the MAP sensor.n
8.Remove the jumper wire.
9.Measure voltage between the MAP sensor 3P connector terminals No. 1 and No. 3.
IMAGE REPLACED HERE
Is there about 5 V?
YES - Go to 10.
NO - Repair open in the wire between the ECM/PCM (A11) and the MAP sensor.n
10.Turn the ignition switch OFF.
11.Connect ECM/PCM connector terminals A11 and A19 with a jumper wire.
IMAGE REPLACED HERE
12.Turn the ignition switch ON (II).
13.Check the MAP with the HDS or the scan tool.
Is about 101 kPa (760 mmHg, 30 in.Hg) or higher, or about 2.9 V or higher indicated?
YES - Update the ECM/PCM if it does not have the latest software, or substitute a known-good ECM/PCM, then recheck. If the symptom/indication goes away with a known-good ECM/PCM, replace the original ECM/PCM.n
NO - Repair open in the wire between the ECM/PCM (A19) and the MAP sensor.n
connector. 5.