Advertisement [ ? ]
Site Links
- Lease Calculator
- Advertise
- My Car ongoing Review
- Members' Chat
- Cars For Sale
- Car Dealers
- Honda "Fit" Manual
- Hyperflex Bushings
- For Sale
- Fix your Car
- Car Manuals
- other manuals - Reference Materials
- DIY Repairs
- Articles
- Video
- Link with Us
- Search Help
- Code your Mac!
- Fly, race, anything R/C
Honda Fit/Jazz - DTC Troubleshooting: 23-5
Online Honda Fit/Jazz 2002-2005 Workshop repair manual used by professionals.
Full Membership required
We can not locate your Full (Preferred) membership details. Please login to your account first and if necessary upgrade your membership.
24 Hr or Annual Membership required.
Thank you!
Snip from the Manual
DTC Troubleshooting: 23-5
DTC 23-5: Short to Ground in Left Side Seat Belt Outer Lap Tensioner
Special Tools Required
SRS inflator simulator( 07SAZ-TB4011A)
IMAGE REPLACED HERE
IMAGE REPLACED HERE
1.Erase the DTC memory.
2.Turn the ignition switch ON (II), and check that the SRS indicator comes on for about 6 seconds and then goes off.
Does the SRS indicator stay on?
YES - Go to 3.
NO - Intermittent failure, system is OK at this time. Go to Troubleshooting Intermittent Failures.n
3.Turn the ignition switch OFF. Disconnect the battery negative cable, and wait for 3 minutes.
4.Disconnect the TBL1o connector from the TBL1i connector (A).
IMAGE REPLACED HERE
5.Connect the special tool (2 W connector) to the TBL1i connector.
6.Reconnect the battery negative cable.
7.Erase the DTC memory.
8.Read the DTC.
Is DTC 23-5 indicated?
YES - Go to 9.
NO - Short to ground in the left side seat belt outer lap tensioner; replace the left side seat belt.n
9.Disconnect the battery negative cable, and wait for 3 minutes.
10.Disconnect the both seat belt tensioner 4P connectors from the floor wire harness 4P connectors.
11.Disconnect the TBR1o connector (A) from the TBR1i connector (B).
IMAGE REPLACED HERE
12.Disconnect the U2o connector (A) from the SRS unit.
IMAGE REPLACED HERE
13.Disconnect the SRS inflator simulator (special tool) from the SRS simulator lead E.
14.Check resistance between each terminal of the SRS simulator lead E and body ground. There should be an open circuit, or at least 1 MW.
IMAGE REPLACED HERE
Is the resistance as specified?
YES - Faulty SRS unit; replace the SRS unit.n
NO - Short to ground in the floor wire harness; replace the floor wire harness.n
4. Disconnect