DIY     OBD-II Codes     Fix your Car     Repair Manuals     -Forum-

Advertisement  [ ? ]

Site Links

Digg Twitter FaceBook

Honda Fit/Jazz - DTC Troubleshooting: 11-1

Online Honda Fit/Jazz 2002-2005 Workshop repair manual used by professionals.

Full Membership required

We can not locate your Full (Preferred) membership details. Please login to your account first and if necessary upgrade your membership.
24 Hr or Annual Membership required.

Thank you!

Snip from the Manual


DTC Troubleshooting: 11-1

DTC 11-1: Open or Increased Resistance in Driver's Side Airbag Inflator


Special Tools Required
SRS inflator simulator( 07SAZ-TB4011A)

IMAGE REPLACED HERE

SRS simulator lead E( 07XAZ-S1A0200)

IMAGE REPLACED HERE



1.Erase the DTC memory.

2.Turn the ignition switch ON (II), and check that the SRS indicator comes on for about 6 seconds and then goes off.

Does the SRS indicator stay on?


YES - Go to 3.


NO - Intermittent failure, system is OK at this time. Go to Troubleshooting Intermittent Failures.


3.Turn the ignition switch OFF. Disconnect the battery negative cable, and wait for 3 minutes.

4.Disconnect the SDo connector from the SDi connector (A).

IMAGE REPLACED HERE

5.Connect the special tool (2 W connector) to the SDi connector (A).

6.Reconnect the battery negative cable.

7.Erase the DTC memory.

8.Read the DTC.

Is DTC 11-1 indicated?


YES - Go to 9.


NO - Open or increased resistance in the driver's side airbag; replace the driver's side airbag.n


9.Disconnect the battery negative cable, and wait for 3 minutes.

10.Disconnect the TL1o and TR1o connectors (A) from the TL1i and TR1i connectors (B).

IMAGE REPLACED HERE


11.Disconnect the U2o connector (A) from the SRS unit.

IMAGE REPLACED HERE

12.Disconnect the SRS inflator simulator (special tool) from the SRS simulator lead C.

13.Check resistance between the A and B terminals of the SRS simulator lead C (special tool). There should be 1.0 W or less.

IMAGE REPLACED HERE

Is the resistance as specified?


YES - Faulty SRS unit or poor contact at the U2o connector and the SRS unit, check the connection between the U2o connector and the SRS unit. If the connection is OK, replace the SRS unit.n


NO - Open or increased resistance in the floor wire harness; replace the floor wire harness.n

4. Disconnect


Honda Fit/Jazz 02-05 Workshop Manual    Back to all Manuals