DIY     OBD-II Codes     Fix your Car     Repair Manuals     -Forum-

Advertisement  [ ? ]

Site Links

Digg Twitter FaceBook

Honda Fit/Jazz - DTC Troubleshooting: 1-3

Online Honda Fit/Jazz 2002-2005 Workshop repair manual used by professionals.

Full Membership required

We can not locate your Full (Preferred) membership details. Please login to your account first and if necessary upgrade your membership.
24 Hr or Annual Membership required.

Thank you!

Snip from the Manual


DTC Troubleshooting: 1-3

DTC 1-3: Short to Another Wire or Decreased Resistance in Driver's Airbag Inflator


Special Tools Required
SRS inflator simulator( 07SAZ-TB4011A)

IMAGE REPLACED HERE

SRS simulator lead F( 07XAZ-SZ30100)

IMAGE REPLACED HERE



1.Erase the DTC memory.

2.Turn the ignition switch ON (II), and check that the SRS indicator comes on for about 6 seconds and then goes off.

Does the SRS indicator stay on?


YES - Go to 3.


NO - Intermittent failure, system is OK at this time. Go to Troubleshooting Intermittent Failures.


3.Turn the ignition switch OFF. Disconnect the battery negative cable, and wait for 3 minutes.

4.Disconnect the D1i connector from the D1o connector (A).

IMAGE REPLACED HERE

5.Connect the special tool (2 W connector) to the D1o connector (A).

6.Reconnect the battery negative cable.

7.Erase the DTC memory.

8.Read the DTC.

Is DTC 1-3 indicated?


YES - Go to 9.


NO - Short in the driver's airbag; replace the driver's airbag.n


9.Disconnect the battery negative cable, and wait for 3 minutes.

10.Disconnect the U1o connector (A) from the SRS unit. Do not disconnect SRS simulator lead F from cable reel 4P connector.

IMAGE REPLACED HERE

11.Disconnect the SRS inflator simulator (special tool) from the SRS simulator lead F.

12.Install the special tool (070AZ-SAA0100) to No. 7 and No. 8 terminals of the U1o connector.

13.Check resistance between the terminals of SRS simulator lead F. There should be 1 MW or more.

IMAGE REPLACED HERE

Is the resistance as specified?


YES - Replace the the SRS unit.n


NO - Go to 14.


14.Disconnect the D2o connector (A) from the D2i connector (B).

IMAGE REPLACED HERE

15.Check resistance between the terminals of SRS simulator lead F. There should be 1 MW or more.

IMAGE REPLACED HERE

Is the resistance as specified?


YES - Replace the dashboard wire harness.n


NO - Replace the cable reel.n

minutes. 4.


Honda Fit/Jazz 02-05 Workshop Manual    Back to all Manuals